Cleaning The Cable And Sensor Remote Control; Storing The Sensor After Use; Maintaining The Sensor - Kodak RVG User Manual

Cleaning the Cable and
Sensor Remote Control
Clean the cable carefully, using a disinfecting wipe.
To clean the cable and sensor remote control, hold the
sensor in one hand and with the other hand run the
wipe from the end of the sensor over the first twelve
inches of the cable without pulling on the cable
insulation. Slide the wipe without force, pinching the
cable between the fingers with minimal pressure.
Storing the Sensor After
Use
It is strongly recommended that you store the sensor in
its case at the end of the day to prevent it from falling
or from coming into contact with abrasive cleaning
products when your office is being cleaned.

Maintaining the Sensor

To maintain the life of the sensor, do the following:
•
Do not place the sensor in a sterilizer or autoclave.
•
Do not pull on the cable, even when removing the
disposable protective sheath.
•
Do not walk on or roll objects over the cable.
•
Do not request the patient to bite on the sensor or
the cable.
KODAK RVG Digital Radiography Systems User's Guide (CS4000_en)
Maintaining the Sensor
Important
Follow these
guidelines to prevent
damage to the sensor.
4–3