Remote Sensor; Getting Started; Power Supply - Oregon Scientific RMR329P User Manual

REMOTE SENSOR

1
1. LED status indicator
2. Wall mount hole
3. Battery compartment
4. RESET hole: Reset unit to default settings
5. CHANNEL button: Select channel 1

GETTING STARTED

POWER SUPPLY

Batteries serve as a back-up power supply. For
continuous use of projector and backlight, install
adapter. The socket-outlet shall be installed near the
equipment and shall be easily accessible.
NOTE will appear when power supply is not
connected.
RMR329P_M_EN_R1.indd 3
2
4
3
5
3
To insert batteries:
1. Remove the batter y compar tment and inser t
batteries, matching polarities.
2. Press RESET after each battery change.
MEANING
LOCATION
Clock / alarm area Main unit batteries low
Outdoor / indoor
Sensor batteries low
temperature area
REMOTE SENSOR
To set up the sensor:
1. Open the battery compartment, and insert batteries,
matching polarities.
2. Place the sensor within 30 m (98 ft) of the main
unit using the table stand or wall mount.
The transmission range may vary depending on many
factors. You may need to experiment with various
locations to get the best results.
6/21/07 12:45:23 PM