Battery Installation & Charging - AT&T EP5632 User Manual

Getting started
Battery installation & charging
Install the battery as shown below. After installing the battery, you can make
and receive short calls, but replace the handset in the telephone base or
charger when not in use. For optimal performance, charge the handset battery
for at least 16 hours before use. When fully charged, the handset battery
provides approximately five hours of talk time and three days of standby
time.
1. Press the tab and
slide the battery
c o m p a r t m e n t
cover downwards.
(if necessary)
4. Charge the handset facing
up in telephone base, or
place the handset in the
charger (EP5632-2 only).
The CHARGE light will be
on when charging.
IMPORTANT INFORMATION
• Use only the battery supplied with this product. To order a replacement
or spare battery (AT&T model 103, part number 89-0429-00-00) or
equivalent, visit our website at
1 (800) 222-3111
• See the Troubleshooting section on page 94 for charging issues.
2. Insert the supplied battery
as indicated. Insert the top
edge (contacts and tab) in
first, then push downwards
on the lower portion of
the battery.
www.telephones.att.com
. In Canada, dial
14
3. Align the cover flat
1 (866) 288-4268
against the battery
compartment, then
slide it upwards until
it clicks into place.
, or call
.