Table of Contents
Advertisement
Step 3: Install the Handset Batteries
CAUTION: To reduce the risk of fire or personal injury, use only the Thomson Inc. approved model GP 75AAAHC 1.2V
750mAh, rechargeable Nickel-metal Hydride AAA batteries, which are compatable with this unit.
Please refer to
www.thomson-store.com
from other sources.
NOTE:
You must connect the handset battery before use.
• Slide the battery door off the back of the Handset.
• Insert the batteries (included) into the housing in the Handset being careful to align the + / - ends correctly
(refer to the graphics in the housing).
Attention
- special care should always be taken
with the loudspeaker - never allow anything to
poke through or pour into the holes. It is very
delicate.
• Check that the screen lights up, then replace the cover.
• Wait for about 30 seconds to allow the system to start up.
• When your Handset is registered to its Gateway,
the screen displays the number "1" alongside the
with your Gateway is "pre-registered" to the Gateway.
To register additional Handsets, please refer to page 35)
Battery Safety Precautions
• Do not burn, disassemble, mutilate, or puncture. Like other batteries of this type, toxic materials could be
released which can cause injury.
• To reduce the risk of fire or personal injury, use only the Nickel-metal Hydride battery listed in the
User's Guide.
• Keep batteries out of the reach of children.
• Remove batteries if storing over 30 days.
3660181C
to purchase approved batteries or for a list of approved batteries available
NOTE: The RBRC seal on the battery used in your Thomson Inc. product
indicates that we are participating in a program to collect and recycle the
rechargeable battery (or batteries).
For more information go to the RBRC web site at www.rbrc.org
or call 1-800-8-BATTERY or contact a local recycling center.
(green - has signal) symbol. The handset packaged
Charging and Batteries
8
Advertisement
Table of Contents
