Table of Contents
Advertisement
64
What to do if ...
What to do if ...
Problem
The cooking zones are not
functioning
The oven does not heat up
The oven lighting is not op-
erating
The oven is not heating up.
Time (TAGESZEIT) is lit.
F11 appears in the clock
display
An error code not listed
above appears in the time
display
If you are unable to remedy the problem by following the above sugges-
tions, please contact your dealer or the Customer Care Department.
Possible cause
Consult the operating instructions for the built-in cooking surface
The oven has not been switched
on
The clock has not been set
The required settings have not
been set
The oven's automatic cut-out
has been triggered.
The house wiring fuse (in the
fuse box) has tripped
The oven light bulb is faulty
Demo mode is on.
The meat probe has short
circuited or the plug of the meat
probe is not firmly in position in
the socket
Fault in the electronics
Remedy
Switch the oven on
Set the current time on the clock
Check the settings
See Automatic cut-out
Check fuse. If the fuses trip sev-
eral times, please call a qualified
electrician
Replace oven bulb
Keep Selection (AUSWAHL) but-
ton pressed for 2 seconds, then
within 2 seconds press and hold
Selection (AUSWAHL) and
buttons for 2 seconds
Insert the plug of the meat
probe as far as it will go into the
socket on the side wall of the
oven
Switch off the appliance via the
house fuse or the safety switch
in the fuse box and switch it on
again.
If displayed again, please contact
the Customer Care Department
Advertisement
Table of Contents
