To Place A Call On Remote Hold - NEC DT310 User Manual

To Retrieve:
Lift handset or press Speaker key.
Press held line. User handset to converse.
Only phone that set Exclusive Hold option can
Note:
retrieve the call.
If Unanswered:
After preprogrammed time, Automatic Recall is
initiated.
Visual and audible signal (rapid flash and ring
burst) is sent to station that placed call on hold.
Recall shows as a flashing green LED on your
phone, and solid red on other phones with same
line.
Exclusive Hold excludes any other phone from
Note:
picking up your held call. Exclusive Hold
shows as a flashing green LED on your phone.
the same line on other phones appears as a
solid red LED.

To Place a Call on Remote Hold

To Initiate:
While in conversation with Station/Trunk Party
Press the Transfer key. Receive interrupted dial
tone.
Dial destination station's extension.
Receive ring back tone.
Press the Hold key. (Call is placed on hold at the
destinations station's extension)
Hang up.
To Retrieve At Destination:
Lift handset or press Speaker key.
Press line on hold. User handset to converse.
Any station with the destination line
Note:
appearance can retrieve the call.
To Retrieve From Phone Without Destination
Line Appearance:
Lift handset or press Speaker key.
Dial Access Code for Direct Call Pick-Up.
Dial destination station's extension.
Use handset to converse.
36