Installation; Connecting To The Mains - Electrolux EMS 1882 Instruction Manual

EMS 1882
1. Remove any promotion label from the door.
2. The oven should be installed on a flat, level
surface. The surface must be strong enough
to safely bear the weight (14 kg) of the oven,
and the contents. To avoid the possibility of
causing vibration or noise the oven must be
in a stable position.
3. Keep the oven away from heat and water.
Exposure to heat and water can lower oven
efficiency and lead to malfunctioning, so be
sure to install the oven away from heat and
water sources.
4. Do not block air vents on the top and the
sides of the cabinet and also do not place any
articles on the top of the oven. If air vents
are blocked during operation, the oven may
overheat, and this may lead to
malfunctioning. Hot air escapes from the
vents, so be sure not to obstruct it or let
curtains come between the oven and the
rear wall.
5. Place the oven as far away from radios and
TV's as possible. This oven does conform to
EEC requirements of radio interference sup-
pression, but some interference may occur if
it is placed too close to a radio or TV, so
keep them as far apart as possible.
6. If positioned in a corner, leave a gap of at
least 5 cm from the walls and 10 cm above
the microwave.
IMPORTANT! The oven can be placed almost
anywhere in the kitchen. Make sure the oven is
placed on a flat, level surface and that vents as
well as the surface underneath the oven are
not blocked (for sufficient ventilation).

Installation

Connecting to the mains

The oven is delivered with the power cord and a
plug for 230–240 V, 50Hz, earthed socket
outlet.
Earth protection minimizes the risks should a
short circuit occur. Check to ensure the voltage
of the oven matches the supply.
N.B. If the oven is connected to the socket via
an extension cord, make sure the cord is
earthed.
!
This appliance must not be used on a
non earth protected power supply.
Contact an electrician if you are
uncertain regarding electrical
connection of the oven or
provision of earth protection of the
supply.This appliance must be
earthed. If this appliance is fitted with
a non-rewirable plug for which your
socket is unsuitable, the plug should
be cut off and the appropriate plug
fitted. If it is necessary to change the
fuse in a nonrewirable plug, the fuse
cover must be refitted. If the fuse
cover is lost or damaged, the plug
must not be used until a replacement
is obtained.
8
English