Tpm Embedded Security Device (Select Models Only); Using Internet Security Software; Using Antivirus Software - HP ENWW User Manual

TPM Embedded Security device (select models only)

TPM (Trusted Platform Module) provides additional security for your computer. You can modify the
TPM settings in Setup Utility. For information on changing Setup Utility settings, see
Utility (BIOS) and HP PC Hardware Diagnostics (UEFI) on page
The following table describes the TPM settings in Setup Utility.
Settings
TPM Embedded Security Device
TPM Status
Embedded Security State
TPM Set to Factory Defaults

Using Internet security software

When you use your computer to access email, a network, or the Internet, you potentially expose your
computer to computer viruses, spyware, and other online threats. To help protect your computer,
Internet security software that includes antivirus and firewall features may be preinstalled on your
computer as a trial offer. To provide ongoing protection against newly discovered viruses and other
security risks, security software must be kept up to date. It is strongly recommended that you upgrade
the security software trial offer or purchase the software of your choice in order to fully protect your
computer.

Using antivirus software

Computer viruses can disable programs, utilities, or the operating system, or cause them to function
abnormally. Antivirus software can detect most viruses, destroy them, and in most cases, repair any
damage they have caused.
ENWW
Function
Available/Hidden
●
If the administrator password is set, you can select Available.
●
If you select Hidden, the TPM device is not visible in the operating
system.
Enabled/Disabled
●
If the administrator password is not set, or if TPM Security Device is set
to Hidden, this entry is hidden.
●
This value reflects the current physical state for the TPM. The state is
enabled or disabled by the Embedded Security State setting.
No Operation/Disabled/Enabled
●
If the administrator password is not set, or if TPM Security Device is set
to Hidden, this entry is hidden.
●
You can enable or disable the TPM function.
●
The next time the computer is restarted after the TPM function is set, this
value is set to No Operation.
No/Yes
●
If the administrator password is not set, or if the TPM Security Device is
set to Hidden, this entry is hidden.
●
If the Embedded Security State is set to Enabled, select Yes to reset
the TPM to factory settings, and then press
confirmation message is displayed to Clear the TPM. Press
the TPM, or press f2 to cancel the action.
TPM Embedded Security device (select models only)
Using Setup
68.
f10 to save and exit. A
f1 to reset
65