MULTIQUIP Power Ultra-Silent DCA-85USJ Operation And Parts Manual page 37

DCA-85USJ — GENERATOR START-UP PROCEDURE (MANUAL)
Starting (Manual)
8. Place the MPEC Control Switch in the MANUAL
position to start the engine (Figure 42).
Figure 42. MPEC Control Switch
(Manual Position)
In cold weather conditions, placing the MPEC Control
Switch in the MANUAL position will preheat and start
the engine AUTOMATICALLY. The Preheat Lamp
(Figure 43) will turn off when the engine has started.
7. Once the engine starts, let the engine run for 1-2 minutes.
Listen for any abnormal noises.
Figure 43. Pre-Heat Lamp
8. Verify that the Engine Running
status LED on the MPEC unit
(Figure 44) is ON (lit) after the
engine has been started.
Figure 44. Engine
Running LED (ON)
DCA-85USJ — OPERATION AND PARTS MANUAL — REV. #0 (09/17/04) — PAGE 37
9. The generator's frequency meter (Figure 45) should be
displaying the 60 cycle output frequency in HERTZ.
Figure 45. Frequency Meter (Hz)
10. The generator's AC-voltmeter (Figure 46) will display the
generator's output in VOLTS. If the voltage is not within
the specified tolerance, use the voltage adjustment
control knob (Figure 47) to increase or decrease the
desired voltage.
Figure 46. Voltmeter
Figure 47. Voltage Adjust Control Knob
11. The ammeter (Figure 48) will
indicate zero amps with no load
applied. When a load is applied, the
ammeter will indicate the amount
of current that the load is drawing
from the generator.
Figure 48. Ammeter (No Load)
1