Hood Sensor
Description
Hood sensor
The hood sensor is attached in a slot in the rear of the chassis.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Unplug the sensor cable from the system board connector labeled HSENSE (1).
4.
Slide the hood sensor straight out of the notch in the chassis (2).
NOTE:
Figure 7-40
To install the hood sensor, reverse the removal procedure.
(Access Panel on page
A flat blade screwdriver can be used to push the hood sensor out of the slot.
Removing the hood sensor from the chassis fan
(Preparation for Disassembly on page
93).
Spare part number
638816-001
92).
Hood Sensor 125