Table of Contents
Advertisement
activated under the following circumstances as it will erase the time and station
pre-set memories.
1. Upon initial installation after wiring is completed.
2. If there is a malfunction of any of the switches on the unit, pressing the
Re-Set button may clear the system and return to normal operation.
1. Switch the vehicle ignition "on" and the radio "off" (the time will be shown on
the display panel).
2. Press and hold the Time/Frequency Selector (T/F) (29) for approximately 2
seconds until the time display begins flashing.
3. Within 5 seconds of the display beginning to flash, press the Manual Down
Tuning (
) side of button (10) to adjust the hours and the Manual Up Tuning
(
) side of the button to adjust the minutes to the correct time.
3. After setting the correct time, press the Time/Frequency Selector (T/F) again
or wait 5 seconds for the display to stop flashing.
If a problem should develop while operating the CD player, the following error
sign indications may appear on the display panel.
E:01 Indicates an error in the microprocessor control of the CD player.
Eject the disc, make sure it is clean, undamaged and loaded
correctly (label side up). You may also try activating the Re-Set
button (30) on the unit, but this will also erase the time and pre-set
memories.
E:03 Indicates an error has occurred in the laser focus on the disc. Eject
the disc, make sure it is clean, undamaged and loaded correctly
(label side up). Re-load the disc and check for proper operation or
try another disc.
E:07 Indicates that the disc may be loaded in the player upside-down.
Re-load disc properly if necessary. May also indicate that the disc
is dirty in which case, clean the disc and re-load it.
If the suggested measures do not solve the problem, contact your car stereo
specialist or service facility for further assistance.
SETTING THE CLOCK
CD PLAYER ERROR SIGNS
7
Advertisement
Table of Contents
