Weber SP 200 NG Owner's Manual page 27

d) Unlatch the Spider Stopper Guards and remove.
Figure 9.
e) Remove the manifold bracket and unscrew the two
wing nuts that hold the manifold to the cooking box.
Pull the manifold and valve assembly out of the
burners and carefully set it down. Figure 10.
Figure 10
f) Slide the burner assembly out from under the guide
screw and washer in the corners of the cooking box.
Figure 11.
Guide screw
Figure 11
Figure 9
View from behind
cooking box
Wing nuts
g) Lift and twist the burner assembly slightly, to
separate the crossover tube from the burners.
Figure 12. Remove the burners from the cooking
box.
Crossover tube
h) To reinstall burners, reverse steps c) through g).
i) Reinstall the Spider Stopper Guards. Slightly rotate
the Spider Stopper Guards so that the seams are in
line with the Venturi fins. There should be no gaps in
the seams or in the fit around the burners and
valves. Figure 13.
Venturi fin
Check fit around burner
CAUTION: If the Spider Stopper Guards do not fit
tightly, contact your dealer.
CAUTION: After reinstalling the gas lines, they
should be leak checked with a soap and water
solution before using the barbecue. (See Step
"Check for gas leaks".)
27
Figure 12
Check fit around
valve
Figure 13