Weber SP 200 NG Owner's Manual page 18

Step 16
Install the lid
You will need: lid, two hinge pins and two hair pin cotters.
Set the lid in place. Align the hinges at the rear of the
barbecue. Insert hinge pins from the outside. Insert hair
pin cotters into the small holes in the hinge pins.
Figure 21.
Figure 21
Hair pin cotter
Hinge pin
Step 17
Install tool holders, control panel and burner
control knobs
You will need: three tool holders, control panel and three
burner control knobs.
Hook the tool holders over the frame rail. Figure 22.
Set the control panel in place over both frame braces.
(Hold the Crossover Ignition button up while setting the
control panel in place.) Place your thumbs over the
control panel push-in buttons and push them into the
frame brace until they snap into place. Figure 22 (a).
Push on the burner control knobs. Figure 22 (b).
Hole in frame brace
Tool holders
Figure 22
18
(a)
Control panel
push-in buttons
(b)