Weber SP 200 NG Owner's Manual page 12

Step 7
Add cooking box
You will need: frame assembly, cooking box assembly,
1/4-20 x 2 inch bolt, nylon washer, 1/4-20 keps nut,
pliers and a 7/16 inch wrench.
Turn frame assembly right side up.
Set the cooking box into the frame so the burner tubes
are under the frame brace. Figure 6.
Slide the cooking box to the left within the frame. Put the
washer on the bolt. Insert the bolt through the cooking
box and frame with the head of the bolt outside the box.
Figure 7. Add keps nut. Tighten by holding the bolt with
pliers while you tighten the nut with the 7/16 inch wrench.
Burner tubes
Frame brace
Figure 6
Figure 7
Your Weber Gas Barbecue burner assembly has been
factory assembled, pressure and flame tested. As a
safety precaution we recommend you check the burner
alignment:
a) Do the valves fit into the ends of the burners?
Figure 8 (a).
b) Are the ends of the burners under the washers at
the left rear and left front of the cooking box? The
screws are only guides. Do not tighten. Figure 8 (b).
c) Are the wing nuts under the burner assembly
hand tight? Do not tighten with pliers. Figure 8 (c).
If you answered YES to a, b and c, the burners are
correctly aligned. If you answered NO, the burners are
misaligned. Contact your dealer. Do not use your
barbecue.
Guide screw
(b)
Figure 8
12
(a)
(c)
Wing nuts