Weber SP 200 NG Owner's Manual page 11

Step 4
Continue frame assembly
You will need: frame assembly, wheel frame assembly,
front panel, caster frame, four 1/4-20 x 1/2 inch bolts,
four nylon washers and a 7/16 inch wrench.
Place the caster frame onto the tabs of the left frame
with the dimple to the inside. Figure 3. Place the wheel
frame onto the tabs of the right frame with the dimple to
the inside. Figure 3.
The leg tabs must be on the inside of the frames.
Add front panel with hole down and to your right. Add
the washers to the bolts, insert in the holes as shown
and tighten with the wrench. Figure 3.
Dimples to
the inside
Figure 3
Step 5
Complete frame assembly
You will need: partial frame assembly, two frame
connectors, four 1/4-20 x 2 inch bolts, four nylon
washers and a 7/16 inch wrench.
Hold one frame connector between the caster and
wheel frame. Add nylon washers to the bolts. Put the
bolts through the frame and screw into frame connector.
Tighten.
Repeat procedure with the other frame connector.
Figure 4.
Figure 4
Step 6
Insert casters
You will need: frame assembly and two casters.
Push the casters firmly into the inserts in the ends of the
caster legs. Figure 5.
Figure 5
11