Weber Skyline 3200 LP Owner's Manual page 17

To perform leak checks: Slide back the collar of the quick
disconnect. Push male fitting of the hose into the quick
disconnect, and maintain pressure. Figure 16 (a). Slide
the collar closed. Figure 16 (b). If it does not engage or
lock, repeat procedure. Gas will not flow unless the quick
disconnect is properly engaged.
Turn on gas supply.
To barbecue
(a)
Male fitting
WARNING: Do not ignite burners while leak checking.
Check for leaks by wetting the connections with the soap
and water solution and watching for bubbles. If bubbles
form or if a bubble grows there is a leak.
Locking shut off
Outside
house wall
Collar
(b)
Quick disconnect
engaged
Figure 16
Check:
a) Hose to manifold connection. Figure 17 (a).
b) Manifold to side burner hose connection.Figure 17 (b).
WARNING: If there is a leak at connection (a),
retighten the fitting with a wrench and recheck for
leaks with soap and water solution.
If a leak persists after retightening the fitting, turn OFF
the gas. DO NOT OPERATE THE BARBECUE. Contact
Weber-Stephen Customer Service.
c) Side burner hose to side burner connection.
Figure 17 (c).
d) Valves to manifold connections. Figure 17 (d).
e) Hose to quick disconnect connection. Figure 17 (e).
WARNING: If there is a leak at connections
(b), (c), (d) or (e), turn OFF the gas. DO NOT OPERATE
THE BARBECUE. Contact Weber-Stephen Customer
Service.
When leak checks are complete, turn gas supply OFF at
the source and rinse connections with water.
(a)
Figure 17
17
(b)
(e)
(c)
(d)