Add/Edit An Acl Rule - ZyXEL Communications SBG3300-N000 User Manual

15.4.1 Add/Edit an ACL Rule

Click Add new ACL rule or the Edit icon next to an existing ACL rule in the Access Control
screen. The following screen displays.
Figure 101 Access Control: Add/Edit
The following table describes the labels in this screen.
Table 76 Access Control: Add/Edit
LABEL
Filter Name
Order
Direction
Select Source
Device
Source IP
Address
Select
Destination
Device
Destination IP
Address
IP Type
SBG3300-N Series User's Guide
DESCRIPTION
Enter a descriptive name of up to 16 alphanumeric characters, not including spaces,
underscores, and dashes.
You must enter the filter name to add an ACL rule. This field is read-only if you are editing
the ACL rule.
Select the order of the ACL rule.
Select the direction of the ACL rule. You may select from WAN to LAN, WAN to Router,
WAN to DMZ, LAN to WAN, LAN to Router, LAN to DMZ, DMZ to WAN, DMZ to LAN,
and DMZ to Router. The DMZ zone is available when there's a specified DMZ group.
Select the source device to which the ACL rule applies. If you select Specific IP Address,
enter the source IP address in the field below.
Enter the source IP address.
Select the destination device to which the ACL rule applies. If you select Specific IP
Address, enter the destiniation IP address in the field below.
Enter the destination IP address.
Select whether your IP type is IPv4 or IPv6.
Chapter 15 Firewall
257