Mounting; Orientation; Rigging - Chauvet LED PAR 64 Tri-B User Manual

Mounting

Orientation

Rigging

3. Setup
Mount the LED PAR 64 TRI-B in any position, provided there is adequate room for ventilation.
Be sure that the structure can support the weight of the fixture. Please see the "Technical
Specifications" section of this manual for a detailed weight listing. Mount the fixture securely. This
may be done with a screw, nut and bolt, or a hanging clamp. The hole in each bracket is 13 mm
in size. When rigging consider routine maintenance and control panel access. Please see the
following notes on installation.
·
Be sure to orient the gel frame release so that it is pointing up. Please see the diagram
below for a visual reference.
·
If the power link out is intended to be used with multiple fixture, take into account the
length of each power cable, and mount the fixtures close enough to one another to
accommodate for this.
·
There is a secondary portion of the bracket, which may be used primarily for floor
standing positions.
·
When aiming the fixtures, you may use the bracket adjustment knob. Loosen the knob,
adjust to the desired angle, and then tighten the knob by turning clockwise. Do not use
tools for this step, as it may cause damage.
·
Safety cables must always be used.
Secondary
Mounting bracket
Primary
Mounting Bracket
Do not use a tool on
the bracket
adjustment knob
Gel Frame Release
7 6/21/2013 4:33 PM