Description Of The Item "Data Output Mode - A&D HR-250AZ Instruction Manual

10-5 Description of the Item "Data Output Mode"

The parameter setting of the "Data output mode ( prt )" applies to the performance when the data is
transmitted using the RS-232C serial interface.
Key mode
When the PRINT key is pressed with the stabilization indictor turned on, the balance outputs the
weight data and the display blinks one time.
Required setting
Auto print modes A and B
When the displayed value is stable and the conditions of "Auto print polarity", "Auto print difference"
and reference value are met, the balance outputs the weight data.
When the PRINT key is pressed with the stabilization indictor turned on, the balance outputs the
data and the display blinks one time.
Mode A: Example
Required setting
Mode B: Example
Required setting
Stream mode
The balance outputs the weight data at the specified display refresh rate, regardless of the display
condition. The display does not blink in this mode
Example
Required setting
Caution
The balance may not transmit the data completely at the specified display refresh rate and
baud rate. Set the baud rate higher.
Key mode B
When the PRINT key is pressed, the balance outputs the weight data, regardless of the display
condition. The display does not blink in this mode.
Required setting
Key mode C
When the PRINT key is pressed with the stabilization indictor turned on, the balance outputs the
weight data. When the stabilization indicator is not on, the balance waits for the indicator to turn on
and outputs the data. The balance blinks one time in this mode.
Required setting
dout prt 0
"For outputting the weight value each time a sample is added (or
removed), with "ar-d" set to "1" (to adjust zero after the data is
output)."
dout prt 1
dout ap-p
dout ap-b
dout ar-d 1
"For outputting the weight value while a sample is added."
dout prt 2
dout ap-p
dout ap-b
"For monitoring data on the AD-8920A remote display
dout prt 3
ba5fnc 5pd
5if bp5
dout prt 4
dout prt 5
43
Key mode
Auto print mode A (reference = zero)
Auto print polarity
Auto print difference
Adjusts zero automatically.
Auto print mode B (reference = last stable value)
Auto print polarity
Auto print difference
Stream mode
Display refresh rate
Baud rate
Key mode B
Key mode C