Description Of The Item "Data Output Mode - A&D FZ-1200CT Instruction Manual

Zero tracking ( trc )
This function tracks zero point drift caused by changes in the environment and stabilizes the zero
point. When the weight data is only a few digits, turn the function off for accurate weighing.
Note
Digit, when used for the FZ-CT and FX-CT series balances, indicates a unit of minimum
weighing value.
trc 0
trc 1
trc 2
trc 3
Display refresh rate ( 5pd )
Period to refresh the display. This parameter influences "Stream mode" along with "Baud rate" and
"Data output pause"
Note
This item is selected automatically when the response rate is changed.
Decimal point ( pnt )
The decimal point format can be selected.
Auto display-ON ( p-on )
When the AC adapter is connected, the display is automatically turned on in the weighing mode,
without the ON:OFF key operation. Used when the balance is built into an automated system. A one
hour warm-up is necessary for accurate weighing.
Auto display-OFF ( poff )
When the weight value is 0.5 g or less and no operation such as key input or command receipt is
performed (inactive state) for 10 minutes, the display is automatically turned off and the standby
indicator is illuminated.
(The power consumption is the same for the weighing mode and the display-off state.)

9-5 Description of the Item "Data Output Mode"

The parameter setting of the "Data output mode ( prt )" applies to the performance when the data is
transmitted using the RS-232C serial interface.
Key mode
When the PRINT key is pressed with the stabilization indictor turned on, the balance outputs the
weight data and the display blinks one time.
Required setting
The tracking function is not used. Used for weighing a very light sample.
The tracking function is used. Normal zero tracking.
The tracking function is used. Strong zero tracking.
The tracking function is used. Very strong zero tracking.
dout prt 0
Key mode
29