Table of Contents
Advertisement
1
1. Right floorboard mat
3. Remove the coolant reservoir cov-
er by removing the screw.
2
1
1. Screw
2. Coolant reservoir cover
4. Check the coolant level in the cool-
ant reservoir.
PERIODIC MAINTENANCE AND ADJUSTMENT
TIP
The coolant should be between the
minimum and maximum level marks.
5. If the coolant is at or below the
minimum level mark, open the
coolant reservoir cap, add coolant
to the maximum level mark, and
then close the coolant reservoir
cap. WARNING! Remove only
the coolant reservoir cap. Never
attempt to remove the radiator
cap
when
the
hot.
NOTICE: If coolant is
[EWA15161]
not available, use distilled water
or soft tap water instead. Do not
use hard water or salt water
since it is harmful to the engine.
If water has been used instead
of coolant, replace it with cool-
ant as soon as possible, other-
wise the cooling system will not
be protected against frost and
corrosion. If water has been
added to the coolant, have a
Yamaha dealer check the anti-
freeze content of the coolant as
soon as possible, otherwise the
effectiveness of the coolant will
6-17
be reduced.
1. Minimum level mark
engine
is
2. Maximum level mark
3. Coolant reservoir cap
Coolant reservoir capacity (up to the
maximum level mark):
0.32 L (0.34 US qt, 0.28 Imp.qt)
6. Install the coolant reservoir cover
by installing the screw.
7. Place the right floorboard mat in
the original position.
[ECA10472]
2
1
3
2
3
4
5
6
7
8
9
Advertisement
Table of Contents
Troubleshooting
