OPERATION AND IMPORTANT RIDING POINTS
3-3, 3-7, 3-8 or 3-5 for the corre-
sponding warning light, indicator
light or indicator circuit check.
2. Close the throttle completely.
1
3. Start the engine by pushing the
start switch while applying the front
2
or rear brake. NOTICE: For maxi-
mum engine life, never acceler-
ate hard when the engine is
3
cold!
[ECA11041]
If the engine does not start, re-
4
lease the start switch, wait a few
seconds, and then try again. Each
5
starting attempt should be as short
as possible to preserve the bat-
tery. Do not crank the engine more
6
than 10 seconds on any one at-
tempt.
7
8
9
Starting off
1. While pulling the rear brake lever
with your left hand and holding the
grab bar with your right hand, push
the scooter off the centerstand.
1
1. Grab bar
2. Sit astride the seat, and then ad-
just the rear view mirrors.
3. Switch the turn signals on.
4. Check for oncoming traffic, and
then slowly turn the throttle grip (on
the right) in order to take off.
5. Switch the turn signals off.
5-2
EAU45091
Acceleration and deceleration
(a)
(b)
The speed can be adjusted by opening
and closing the throttle. To increase the
speed, turn the throttle grip in direction
(a). To reduce the speed, turn the throt-
tle grip in direction (b).
EAU16780