Replacing The Tail/Brake Light Bulb Or A Rear Turn Signal Light Bulb; Replacing An Auxiliary Light Bulb - Yamaha CYGNUS.X XC125 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
Replacing the tail/brake light
bulb or a rear turn signal light
bulb
1
2
3
3
4
ZAUM00**
5
1. Tail/brake light lens
2. Turn signal light lens
6
3. Rear turn signal light bulb
4. Tail/brake light bulb
7
Tail/brake light bulb
1. Remove the tail/brake light lens by
removing the screws.
8
2. Remove the defective bulb by
pushing it in and turning it counter-
9
clockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
EAUT1922 screws.
Rear turn signal light bulb
1. Remove the tail/brake light lens by
removing the screws.
4
2. Remove the turn signal light lens
2
1
by removing the screws.
3. Remove the defective bulb by
pushing it in and turning it counter-
clockwise.
4. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
5. Install the turn signal light lens by
installing the screws.
6. Install the tail/brake light lens by in-
stalling the screws.
CAUTION:
Do not overtighten the screws, oth-
erwise the lens may break.
Replacing an auxiliary light
bulb
ZAUM00**
1. Auxiliary light bulb
2. Socket
This model is equipped with two auxil-
iary lights. If an auxiliary light bulb burns
ECA10680
out, replace it as follows.
6-27
1
2
1. Remove panel B. (See page 6-6.)
2. Remove the auxiliary light socket
(together with the bulb) by turning
it counterclockwise.
3. Remove the defective bulb by pull-
ing it out.
4. Insert a new bulb into the socket.
5. Install the auxiliary light socket (to-
gether with the bulb) by turning it
clockwise.
EAUT1962