Configuring Static Route - ZyXEL Communications LTE6100 User Manual

Chapter 6 Routing

6.2 Configuring Static Route

Use this screen to view and configure IP static routes on the LTE Device. Click Network Setting >
Static Route to open the following screen.
Figure 22 Network Setting > Static Route
The following table describes the labels in this screen.
Table 13 Network Setting > Static Route
LABEL
Add New Static
Route
#
Active
Status
Name
Destination IP
Gateway
Subnet Mask
Interface
Modify
46
DESCRIPTION
Click this to set up a new static route on the LTE Device.
This is the number of an individual static route.
This indicates whether the rule is active or not.
A yellow bulb signifies that this static route is active. A gray bulb signifies that this static
route is not active.
This shows whether the static route is currently in use or not. A yellow bulb signifies that
this static route is in use. A gray bulb signifies that this static route is not in use.
This is the name that describes or identifies this route.
This parameter specifies the IP network address of the final destination. Routing is always
based on network number.
This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward packets to
their destinations.
This parameter specifies the IP network subnet mask of the final destination.
This indicates which interface handles the traffic forwarded by this route.
Click the Edit icon to go to the screen where you can set up a static route on the LTE
Device.
Click the Delete icon to remove a static route from the LTE Device.
LTE6100 User's Guide