Epson PowerLite Home Cinema 705HD Quick Setup Manual page 79

Make sure the correct input signal is selected in the Signal menu
■
(see page 50).
If you're using a composite, S-Video, or component video source
■
with 480i signals, turn on the
menu (see page 50).
■ If you've used the Keystone adjustment, you may need to decrease
the setting in the Image menu (see page 48).
Sharpness
■ If you're projecting from a computer, make sure its signal is
compatible with the projector. See page 86.
If you're projecting from a computer, press the
■
the remote control to reset the projector's Tracking, Sync, and
Position settings
The image is blurry.
■ There may be dirt or smears on the lens. Clean the lens as
described on page 60.
Adjust the focus using the focus ring (see page 36).
■
■ If the projector is angled sharply toward the screen, it may not be
possible to focus the entire image. Move the projector to position
it more directly in front of the screen.
Lower the projection angle to reduce the amount of keystone
■
correction required.
Make sure the projector is within the proper range (projection
■
distance) from the screen (see page 19).
Make sure the lens is not fogged by condensation. You may need
■
to wait before using the projector after moving it from a cold
environment to a warm environment.
■ If you're projecting from a computer, you may need to adjust the
tracking and sync settings as described in the next section.
setting on the Signal
Progressive
Auto
button on
Solving Problems
77