Using The Direct Power On Function; Solving Projector Operation Problems - Epson PowerLite Home Cinema 705HD Quick Setup Manual

Error light(s) status
Error light(s) status
P Red
Flashing red
Off

Solving Projector Operation Problems

The power doesn't turn on.
■ If the projector doesn't turn on when you press the Ppower
button, make sure the power cord is connected to the projector
and plugged into a working electrical outlet.
The power cord may be defective. Disconnect the cord from the
■
outlet and contact Epson as described on page 81.
If you're using the Direct Power On function and you
■
immediately plug the power cord back in after unplugging it, the
power may not turn back on. Press the Ppower button to turn
the projector back on.
The buttons on the projector don't work.
If the Control Panel Lock function has been enabled, you can't use the
buttons on the projector. Try using the remote control instead, or
press and hold the projector's
release the lock (see page 56).
Description
The lamp may be burnt out. First make sure the lamp cover is securely
installed. If that's not the problem, the air filter may be clogged. Clean or
replace the air filter as described on pages 60 to 62.
If this does not resolve the problem, let the lamp cool and then remove it. If
the lamp is cracked, replace it as described on page 62. If the lamp is not
cracked, reinstall it. If reinstalling doesn't work, replace the lamp.
If you're using the projector above an altitude of 4,921 feet (1,500 meters),
turn on High Altitude Mode in the Operation menu (see page 53).
If none of these suggestions resolves the problem, contact Epson as
described on page 81.
button for seven seconds to
Enter
Solving Problems
73