Epson PowerLite Home Cinema 705HD Quick Setup Manual page 55

(to project from behind onto a transparent screen), or
Rear
(to project from behind onto a transparent screen
Rear/Ceiling
when the projector is mounted upside-down from the ceiling).
■
Operation
Direct Power On:
projector when you connect the power cord (without pressing the
Ppower button).
: Enable if you want the projector to turn off
Sleep Mode
automatically if it is idle and no signal is received for 1 to 30
minutes (you can adjust the amount of time using the next
setting).
Sleep Mode Timer
period of time before the projector turns off automatically, from
1 to 30 minutes.
Lens Cover Timer
power off automatically when the
more than 30 minutes.
High Altitude Mode
above 4,900 feet (1,500 meters) to ensure that the temperature is
regulated properly. Turn this setting off for lower elevations.
■
Standby Mode
Select
Communication On
monitored and controlled from a computer when it is in standby
mode (the power light is orange).
■ Link 21L
Select to enable the projector to be monitored and controlled
On
from a computer using Link 21L software and the Epson USB
Communication driver.
■ Language
Select a language to use for the projector menus.
Enable if you want to be able to start the
: When Sleep Mode is on, you can set the
: Enabled by default to turn the projector's
A/V Mute
: Enable when you are using the projector
to enable the projector to be
slide is closed for
Fine-Tuning the Projector
note
If you hold down the
A/V
button on the remote
Mute
control for about five
seconds, you switch between
and
Front Front/Ceiling
or and
Rear Rear/Ceiling
If is
Direct Power On
enabled, the power cord is
connected, and a power
outage occurs, the projector
will start when the power is
restored.
note
Do not use the projector at
altitudes above 7,500 feet
(2,286 meters).
53
.