Epson PowerLite Home Cinema 705HD Quick Setup Manual page 74

Error light(s) status
Error light(s) status
P Green or orange
Flashing orange
Off
P Flashing red
Off
Flashing orange
P Red
Off
Red
P Red
Flashing red
Flashing red
P Red
Off
Flashing red
P Flashing red
Flashing red
Flashing red
Solving Problems
72
Description
It's time to replace the lamp. See page 62 for instructions. If you continue
to use the lamp after the replacement warning, there is an increased
possibility that the lamp may break.
Rapid cooling is in progress. Although this is not an abnormal condition,
projection will stop automatically if the temperature rises higher. Make sure
there is plenty of space around and under the projector for ventilation, and
that the air filter and vents are clean.
The projector is overheating, which turns the lamp off automatically.
Wait until the projector switches to standby mode (about 5 minutes). Make
sure there is plenty of space around and under the projector for ventilation.
The air filter may be clogged. Clean or replace the air filter as described on
pages 60 to 62.
If you're using the projector above an altitude of 4,900 feet (1,500 meters),
turn on High Altitude Mode in the Operation menu (see page 53).
If the projector continues to overheat after you clean the air filter, stop
using the projector, disconnect the power cord, and contact Epson for help
as described on page 81.
Warning: Except as specifically explained in this User's Guide, do not
attempt to service this product yourself.
The projector has an internal problem. Stop using the projector, disconnect
the power cord, and contact Epson for help, as described on page 81.
There is a problem with the fan or temperature sensor. Stop using the
projector, disconnect the power cord, and contact Epson as described on
page 81.
The auto iris or ballast is malfunctioning. Unplug the power cord and contact
Epson as described on page 81.