Wall Mounting - ZyXEL Communications NBG5615 User Manual

Table 1 Front panel LEDs (continued)
LED
2.4G/5G WLAN
WPS
USB 1/2

1.8 Wall Mounting

You may need screw anchors if mounting on a concrete or brick wall.
Table 2 Wall Mounting Information
Distance between holes
M4 Screws
Screw anchors (optional)
Select a position free of obstructions on a wall strong enough to hold the weight of the device.
1
Mark two holes on the wall at the appropriate distance apart for the screws.
2
Be careful to avoid damaging pipes or cables located inside the wall
when drilling holes for the screws.
If using screw anchors, drill two holes for the screw anchors into the wall. Push the anchors into the
3
full depth of the holes, then insert the screws into the anchors. Do not insert the screws all the way
in - leave a small gap of about 0.5 cm.
If not using screw anchors, use a screwdriver to insert the screws into the wall. Do not insert the
screws all the way in - leave a gap of about 0.5 cm.
Make sure the screws are fastened well enough to hold the weight of the NBG5615 with the
4
connection cables.
Align the holes on the back of the NBG5615 with the screws on the wall. Hang the NBG5615 on the
5
screws.
NBG5615 User's Guide
COLOR STATUS DESCRIPTION
Green On The NBG5615 is ready and the 2.4GHz/5GHz wireless LAN is on,
but is not sending/receiving data through the wireless LAN.
Blinking The NBG5615 is sending/receiving data through the wireless
LAN.
Off The wireless LAN is not ready or has failed.
Green On WPS is enabled.
Blinking The NBG5615 is negotiating a WPS connection with a wireless
client.
Off WPS is disabled.
Green On The NBG5615 has a USB device installed.
Blinking The NBG5615 is transmitting and/or receiving data from routers
through an installed USB device.
Off There is no USB device connected to the NBG5615.
13 cm
Two
Two
Chapter 1 Introduction
19