ZyXEL Communications NBG5615 User Manual page 17

WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Each WPS connection works between two devices. Both
devices must support WPS (check each device's documentation to make sure).
Depending on the devices you have, you can either press a button (on the device itself, or in its
configuration utility) or enter a PIN (a unique Personal Identification Number that allows one device
to authenticate the other) in each of the two devices. When WPS is activated on a device, it has two
minutes to find another device that also has WPS activated. Then, the two devices connect and set
up a secure network by themselves.
You can use the WPS button (
quickly set up a wireless network with strong security.
Make sure the power LED is on (not blinking).
1
Press the WPS button for more than three seconds and release it. Press the WPS button on another
2
WPS-enabled device within range of the NBG5615.
Note: You must activate WPS in the NBG5615 and in another wireless device within two
minutes of each other.
For more information on using WPS, see
NBG5615 User's Guide
) on the front panel of the NBG5615 to activate WPS in order to
Section 9.2 on page
Chapter 1 Introduction
73.
17