ZyXEL Communications NBG5615 User Manual page 120

Chapter 12 Wireless LAN
Figure 67 Network > Wireless LAN 2.4G/5G > More AP: Edit (the last SSID)
The following table describes the labels in this screen.
Table 43 Network > Wireless LAN 2.4G/5G > More AP: Edit
LABEL
Active
Name (SSID)
Hide SSID
Intra-BSS Traffic
WMM QoS
Enable Guest
WLAN
IP Address
IP Subnet
Mask
120
DESCRIPTION
Select this to activate the SSID profile.
The SSID (Service Set IDentity) identifies the Service Set with which a wireless client is
associated. Enter a descriptive name (up to 32 printable characters found on a typical
English language keyboard) for the wireless LAN.
Select this check box to hide the SSID in the outgoing beacon frame so a station cannot
obtain the SSID through scanning using a site survey tool.
A Basic Service Set (BSS) exists when all communications between wireless clients or
between a wireless client and a wired network client go through one access point (AP).
Intra-BSS traffic is traffic between wireless clients in the BSS. When Intra-BSS is enabled,
wireless clients can access the wired network and communicate with each other. When
Intra-BSS is disabled, wireless clients can still access the wired network but cannot
communicate with each other.
Check this to have the NBG5615 automatically give a service a priority level according to
the ToS value in the IP header of packets it sends.
WMM QoS (Wifi MultiMedia Quality of Service) gives high priority to voice and video, which
makes them run more smoothly.
Select the check box to activate guest wireless LAN. This is available only for the last SSID
on the NBG5615.
Note: Only Router mode supports guest WLAN. AP mode, Universal Repeater mode, WISP
mode and WISP + Universal Repeater mode don't support guest WLAN.
Type an IP address for the devices on the Guest WLAN using this as the gateway IP
address.
Type the subnet mask for the guest wireless LAN.
NBG5615 User's Guide