Remote Management And Nat; System Timeout; Www Screen - ZyXEL Communications NBG5615 User Manual

Chapter 21 Remote Management

21.3.1 Remote Management and NAT

When NAT is enabled:
• Use the NBG5615's WAN IP address when configuring from the WAN.
• Use the NBG5615's LAN IP address when configuring from the LAN.

21.3.2 System Timeout

There is a default system management idle timeout of five minutes (three hundred seconds). The
NBG5615 automatically logs you out if the management session remains idle for longer than this
timeout period. The management session does not time out when a statistics screen is polling. You
can change the timeout period in the Maintenance > General screen

21.4 WWW Screen

To change your NBG5615's remote management settings, click Management > Remote MGMT >
WWW.
Figure 102 Management > Remote Management > WWW
The following table describes the labels in this screen.
Table 71 Management > Remote Management > WWW
LABEL
Port
Access Status
Secured Client IP
Address
Apply
Cancel
174
DESCRIPTION
You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Select the interface(s) through which a computer may access the NBG5615 using
this service.
Select All to allow all computes to access the NBG5615.
Otherwise, check Selected and specify the IP address of the computer that can
access the NBG5615.
Click Apply to save your customized settings.
Click Cancel to begin configuring this screen afresh.
NBG5615 User's Guide