Step 2A Install Hood Onto Wall - GE Monogram ZV30R Installation Instructions Manual

STEP 2A INSTALL HOOD ONTO WALL

SKIP THIS STEP IF INSTALLING BENEATH A SOFFIT OR
CABINET, GO TO STEP 2B.
• Locate at least 2 vertical studs at the wood support.
• Center the supplied wood support, left to right and below the
20" marked line.
20"
Bottom
of
Hood
• Secure the wood support to 2 or more vertical studs, using
at least 2 of the 4 supplied long screws.
IMPORTANT: Screws must penetrate at least 1-1/2" into
vertical studs. Countersink screws into support.
Note: The mounting
screws must remain in
their original shipping
location. These screws
are positioned to engage
the keyhole slots in the
back of the hood.
1/4"
Gap
• Adjust depth of original mounting screws in wood support
until they protrude 1/4" forward. This 1/4" gap will provide
clearance to hang the hood.
Installation Instructions
Wood
Support
Centerline of
Installation
Space
Original Mounting
Screws as Shipped
IMPORTANT: Framing must be capable of
supporting up to 150 lbs.
Install Transition Onto Top of Hood
IMPORTANT: Remove
shipping tape from
damper and check that
damper moves freely.
• Place the duct transition piece over the hood exhaust and secure
with 4 screws provided.
• Use duct tape to seal the connection. Check to be sure the
damper moves freely.
Hang Hood On Wood Support
• Lift the hood and hold close to the installation location. Route
house wiring through the knockout and into the junction box.
• Place the hood over the wood support. Be sure the mounting
screws engage the keyhole slots in the back of the hood. Tighten
the screws.
WARNING:
support while the hood is mounted with only these 2 screws. These
screws will not support the weight of the hood. The hood could
fall resulting in damage or personal injury.
AVERTISSEMENT–
soutien additionnel pendant le montage de la hotte avec ces deux
vis seulement. Ces deux vis ne soutiendront pas le poids de la
hotte. La hotte peut tomber, occasionnant des blessures
corporelles ou des dommages matériels.
• Check to be sure the hood is level and centered.
30"
to
36"
Test Duct Cover Fit
• Place duct cover(s) over the top of the hood to check for
gaps. Adjust the hood up or down if necessary.
Install Bottom Mounting Screws
• Drill 1/8" pilot holes into the two bottom mounting holes.
Enlarge the holes if they did not enter studs to 3/8". Insert
anchors for wall fasteners into bottom holes. Remove
anchor screws and add flat washers provided. Drive
screws into anchors and tighten.
• Install 4 additional screws through the inside back of the
hood and into the wood support.
11
Transition
Continue to provide additional
Continuez à fournir un
Bottom
Mounting
Holes
Centerline of
Installation
Space
Duct