Step 8 Install Decorative Duct Covers; Step 9 Install Hood - GE MONOGRAM ZV1050 Installation Instructions Manual

STEP 8 INSTALL DECORATIVE DUCT COVERS

• Pretap or drive decorative screw into the screw
holes on the support frame. This will make screw
installation easier.
• Separate the two decorative duct covers.
• Select the inside cover (top), which has two screw
holes in the top.
• Slide the decorative duct cover over the support frame
and push to the ceiling.
• Attach to the hood support at the top with 2 supplied
decorative screws.
• Locate the third decorative screw in the hardware
package. Set aside.

STEP 9 INSTALL HOOD

NOTE: AT LEAST THREE PEOPLE ARE REQUIRED
TO COMPLETE THIS INSTALLATION!
• Lift the hood up to the support frame. Carefully align
the hood mounting holes to the support frame holes
and, at the same time, the hood duct connector into
the duct.
• Install screws through the hood and hood support.
• Check hood level in both directions.
• Check to be sure that the duct is positioned over the
hood connector.
• Seal the duct connection with duct tape.
NOTE: Do not drive screws through this duct
connection. Doing so will prevent proper damper
operation.
Installation Instructions
• Slide the lower decorative duct over the installed upper
duct and push to the top, keeping the bottom slotted
hole to the left.
• Install the decorative stop screw in the center hole of
the upper (inner) duct cover. The decorative screw will
act as a stop screw and prevent the lower decorative
duct cover from sliding down.
CAUTION:
installed. Failure to do so could result in personal injury
or damage to the duct cover.
PRUDENCE :
doit être en place, afin d'éviter les blessures ou
d'endommager le capot antipoussière.
13
The stop screw must be
La vis supérieure
Bottom
Duct
Stop Screw
Cover
Install
4 Lock Washers
and 4 Machine Bolts
Apply Duct Tape
to Seal Duct
Connection