Hardware Health Configure - Foxconn P35A Series User Manual

Hardware Health Configure

CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Hardware Health Configure
FAN 1 Mode Setting
Temperature 1 Limit of Hig
Temperature 1 Limit of Sec
Temperature 1 Limit of Thi
Temperature 1 Limit of Low
Fan 1 Highest setting
Fan 1 Second setting
Fan 1 Third setting
Fan 1 Fourth setting
Fan 1 Lowest setting
CPU Temperature
SYS Temperature
CPU Fan Speed
SYSTEM Fan Speed
Vcore
↑↓←→:Move Enter:Select
F7:Previous Values
► Fan 1 Mode Setting (CPU FAN)
This item is used to support SMART CPU FAN feature which allows system to adjust its fan
speed according to CPU temperature. The lower the CPU temperature, the slower the FAN
speed. The options of this setting are :
Auto fan by RPM :
Control CPU FAN by delivering a PWM signal, which supports SMART FAN feature. You
must use 4-wire FAN for this setting. Also, if you are using 3-wire CPU FAN, we recommend
you to choose this setting so it can run at its full speed.
Auto fan by DutyCycle :
Control CPU FAN by using linear voltage, only supports 3-wire CPU FAN. DO NOT
recommend to use this setting for 3-wire CPU FAN, as some old 3-wire FANs may fail to run
by this setting.
Manual fan by RPM :
Manually fix 4-wire CPU FAN running at one particular speed.
Manual fan by DutyCycle :
Manually fix 3-wire CPU Fan running at one particular speed based on a percentage ratio to
the maximum speed. DO NOT recommend.
► Temperature 1 Limit of Highest / Second / Third / Lowest
These items are used to set the CPU temperature limit. When CPU detects itself staying at the
highest temperature, system will drive CPU FAN to run at its maximum speed.
► Fan 1 Highest / Second / Third / Fourth / Lowest Setting
These items are used to set the different levels of the fan speed, 100 is its maximum speed.
► CPU Temperature / System Temperature / CPU Fan Speed / System Fan Speed /
Vcore / 1.8V SUS / 1.2V CoRe / +5V / +12V / +3.3V / VCC / VSb / VbAT
These items display the information of current CPU / chipset / system temperature, fan speeds
and voltages, all these messages are automatically detected and displayed by the system.
Hardware Health Configure
[Auto Fan by RPM]
[Auto Fan by RPM]
[050]
[040]
[030]
[020]
[100]
[080]
[070]
[060]
[050]
:44°C/111°F
:40°C/104°F
:1174 RPM
:N/A
:1.304 V
+/-/:Value F10:Save
F8:Fail-Safe Defaults
42
▲ Help Item
█
█ Fan configuration
█ mode setting
█
█
█
█
█
█
█
█
█
█
▒
▒
▼
ESC:Exit F1:General Help
F9:Optimized Defaults