Usb Functions - Foxconn P35A Series User Manual

OnBoardDevice Configuration
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
JMicron 36x ATA Controller
OnBoardDevice Configuration
Legacy USB Support
USB 2.0 Controller Mode
BIOS EHCI Hand-Off
Initiate Graphic Adapter
PEG Port Configuration
PEG Port

USB Functions

USB 2.0 Controller
HDA Controller
SMBUS Controller
Onboard 1394 Control
JMicron e-SATA&IDE
↑↓←→:Move Enter:Select
F7:Previous Values
► Legacy USB Support
This item is used to enable the support for USB devices on legacy OS. If you have a USB
keyboard or mouse, set to auto or enabled.
► USB 2.0 Controller Mode
This item is used to set the transmission rate mode of USB 2.0. The available settings are :
[HiSpeed] in 480Mbps; [Full Speed] in 12Mbps.
► BIOS EHCI Hand-Off
Windows XP supports a number of features in the Enhanced Host Controller Interface (EHCI)
specification, but there are a few features that are not implemented. Microsoft said preliminary
support for EHCI BIOS handoff will be available in Windows XP SP2.
This item allows you to enable support for OS without EHCI hand-off feature.
This is a workaround for OS without EHCI hand-Off support .
The EHCI ownership change should claim by EHCI driver.
► Initiate Graphic Adapter
In application of multiple graphics cards, this item is used to select which graphics controller is
used as the primary display device during boot. The available values are [PEG/PCI]; [PCI/
PEG]. PEG stands for PCI-Express(x16) graphics card.
► PEG Port Configuration - PEG Port
This item is used to enable/disable the PCI Express Graphics port.
► USB Functions
This item is used to set the USB functions. You can select the amount of enabled USB ports.
► HDA Controller
This item is used to enable/disable the High Definition Audio (HDA) controller on your
motherboard.
► SMBUS Controller
This item is used to enable or disable the SMBUS controller.
The System Management Bus (abbreviated to SMBus) is a simple two-wire bus, derived from
I²C and used for communication with low-bandwidth devices on a motherboard, especially
OnBoardDevice Configuration
[Enabled] [Enabled]
[Enabled]
[FullSpeed]
[Enabled]
[PEG/PCI]
[Auto]
[12 USB Ports]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
+/-/:Value F10:Save
F8:Fail-Safe Defaults
36
▲ Help Item
█
█ Select ATA Controller
█ Operate Mode
█
█
█
█
█
█
█
█
█
▒
▒
▒
▒
▒
▼
ESC:Exit F1:General Help
F9:Optimized Defaults