Advanced Bios Features - Foxconn P35A Series User Manual

Advanced BIOS Features

CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Advanced Settings
WARNING: Setting wrong values in below sections
► IDE Configuration
► SuperIO Configuration
► OnBoardDevice Configuration
↑↓←→:Move Enter:Select
F7:Previous Values
Use the arrow keys to select the option; Press [Enter] to enter the submenu.
The options are discussed below:
IDE Configuration
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
IDE Configuration
SATA Mode Select
SATA#1 Configuration
SATA#2 Configuration
► Primary IDE Master
► Secondary IDE Master
► Third IDE Master
► Third IDE Slave
► Fourth IDE Master
► Fourth IDE Slave
► Fifth IDE Master
► Fifth IDE Slave
► Sixth IDE Master
► Sixth IDE Slave
IDE Detect Time Out (Sec)
↑↓←→:Move Enter:Select
F7:Previous Values
► SATA Mode Select
This item is used to set the operating mode of your SATA ports. The available options are:
[IDe] - This configures the SATA ports to support legacy PATA mode or SATA mode :
[Compatible] - Support legacy PATA modes. Old Linux system only can use this mode.
[Enhanced] - Support SATA specification mode. Old Linux system can not use this mode.
[AHCI] - The Advanced Host Controller Interface (AHCI) specification describes the register
level interface for a Host Controller for Serial ATA. The specification includes a description of
the hardware/software interface between system software and the host controller hardware.
Advanced BIOS Features
may cause system to malfunction.
[Press Enter]
[Press Enter]
[Press Enter]
[Press Enter]
+/-/:Value
F8:Fail-Safe Defaults
IDE Configuration
[IDE]
[Compatible] [Compatible]
[Enhanced]
[Not Detected]
[Not Detected]
[Not Detected]
[Not Detected]
[Not Detected]
[Not Detected]
[Not Detected]
[Not Detected]
[Hard Disk]
[Not Detected]
[35]
+/-/:Value
F8:Fail-Safe Defaults
Help Item
Configure the IDE
device(s).
F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
Help Item
Options
Disabled
Compatible
Enhanced
F10:Save ESC:Exit
F9:Optimized Defaults
33
F1:General Help