Advertisement
3. Begin trimming your beard using smooth, even
strokes. Start with your sideburns and work
downward toward your chin. Never attempt to
trim against the natural growth of your beard
because the hair will be cut too short.
4. If you decide you want a closer trim, you can
now adjust the 5-posi-
tion comb attachment to
a shorter setting (such
as 3/32" or 5/32") and
go over your beard
again until you achieve
the desired length.
blendIng the jawlIne
1. The three jawline attachments will help you to
achieve a neat, finished trim under your chin. To
use one of the attachments, press it down over
the trimmer blades until it clicks into position.
2. Hold the trimmer in an upright position and
begin trimming under your jawline, using short,
even strokes.
3. After your beard is blended, turn off the trimmer
and remove the attachment by gently pulling up on
tab.
to trIm your muStache
1. For best results, start with a
clean, slightly damp mustache.
2. Comb through your mus-
tache in the direction it grows.
3. Place the wide 5-position
comb over the facial hair blade and snap it into posi-
tion. It is a good idea to start with the longest trim
setting adjustment. (You can always go back and cut
your mustache more closely with a shorter setting.)
alwayS trIm your muStache
from the top down
4. After your mustache has been
trimmed to the desired length,
remove the 5-position comb and,
using the blades only, define the
outline of the bottom of your
mustache.
5. Use the scribe blade for fine detailing and hair art.
on/off SwItch
To operate, simply slide switch toward blade, to stop
push slide away from blade.
care of your trImmer
replacement (removal) of blade Set
To remove blade set from
your trimmer, make sure the
trimmer is in the OFF posi-
tion. Remove the blade set by
placing thumb against the
smaller cutter and pushing
forward, releasing the cutter
assembly from the trimmer
housing. Replace with new cutting system and
reverse the removal procedure, only this time
place your thumb on the large cutter and snap
into place. Make sure the taper control is set to
the longest #1 position.
battery removal
CONTAINS NICKEL CADMIUM
BATTERY. MUST BE
COLLECTED, RECYCLED OR
DISPOSED OF PROPERLY. DO
NOT DISPOSE OF IN
THE MUNICIPAL WASTE.
1. Using a small Phillips head screwdriver, remove the
screws at the back of the trimmer.
2. Remove the bottom housing and push the batteries
out. Bring the batteries to the nearest collection centre
for proper disposal. DO NOT throw the batteries into
the normal municipal waste system.
Advertisement
