Download Print this page

User Maintenance Instructions; On/Off Switch - Conair GMT7171WCSC Instruction Booklet

Cordless battery-operated beard & mustache trimmer with nose & ear attachment

Advertisement

Save theSe
InStructIonS
for houSehold uSe only
operatIng InStructIonS:
1. Remove the battery compartment cover by
pushing in and down toward the bottom of the
trimmer.
2. Align the two AA batteries with the positive
and negative positions indicated inside the
battery compartment. Being careful not to
bend the clips, insert the negative end of each
battery first so it will slip easily into position.
3. Return the battery cover to its original position
by pushing it in and up until you hear a small
click as it locks into place.
4. To use your trimmer, push ON/OFF switch
upwards to ON position.
5. After you finish using your trimmer, push
down on the ON/OFF switch to turn the
trimmer off.
6. For your convenience, the trimmer comes
with a storage base to hold the trimmer and
accessories.
uSer maIntenance
InStructIonS
takIng care of your trImmer
oIlIng the bladeS
About once a month you should oil the trimmer
blades with the oil provided in your kit. It is best
to do this over a piece of newspaper. Turn the
trimmer on and hold it so that the blades are
pointed downward. Spread one drop of oil across
the blades, then turn the trimmer off and wipe
away the excess oil with a soft cloth.
Be careful not to use too much oil and don't oil
your trimmer more than necessary, as this could
damage the motor. (Never attempt to oil the
motor bearing, as it is permanently lubricated.)
After oiling the blades, return the trimmer and
oil packet to the trimmer storage base. KEEP OIL
OUT OF REACH OF CHILDREN.

on/off SwItch

To operate, simply push slide toward blade;
to stop, push slide away from blade.
Battery Position
*Requires 2 AA batteries. We recommend using alkaline bat-
teries in your trimmer because they last longer.
1. Always purchase the correct size and grade of
battery most suitable for the intended use.
2. Replace all batteries of a set at the same
time.
3. Clean the battery contacts and also those of
the devise prior to battery installation.
4. Ensure the batteries are installed correctly
with regard to polarity (+ and -).
5. Remove batteries from equipment which is
not to be used for an extended period of time.
6. Remove used batteries promptly.
7. Do not mix old and new batteries. Do not mix
alkaline, standard (Carbon-Zinc), or recharge-
On/Off Switch

Advertisement

loading