Diagnostic Codes - GE GSD4410 Owner's Manual

About the display diagnostic codes.
Display
RESET
12
What It Means
Electrical power to the
dishwasher has been
interrupted but is now
back on.
Slow draining. The
dishwasher is taking
longer than normal to
drain the water out.
This is usually caused
by a blockage in the drain
air gap, a kink in the
drain hose, or a
stopped-up pipe.
What To Do
IF DISHWASHER WAS IN USE WHEN
THE POWER FAILURE OCCURRED:
1 Press the RESET pad and wait
approximately 30 seconds.
2 Unlatch and open the door.
A If the detergent cup is open and
empty and the dishwasher was set
for the NORMAL, POTS PANS or
CHINA CRYSTAL cycle, close
door and put the load through a
RINSE HOLD cycle. After the
RINSE HOLD cycle is completed,
add detergent and reset the load
for the washing cycle you want.
B If the detergent cup is closed and
the dishwasher was set for the
NORMAL, POTS PANS or
CHINA CRYSTAL cycle, reset the
dishwasher for the wash cycle
you want.
C If the dishwasher was set for the
RINSE HOLD cycle, reset the
dishwasher for RINSE HOLD.
IF THE DISHWASHER WAS NOT IN USE
when power failure occurred, use
dishwasher as you normally would.
This dishwasher is designed to
automatically compensate for longer
than normal drain times, but cycle time
will be extended. If this code continues
to appear frequently:
1 Clean the air gap.
2 Check for a kink in the drain hose.
3 Check plumbing for slow or
stopped-up drains.
NOTE: Warranty service does not
cover household drain problems.