GE GSD4410 Owner's Manual page 14

About the display diagnostic codes.
Display
Before You Call For Service
Try the cycle again to see if the code reappears. The dishwasher may
correct itself.
Electronic controls can be affected by outside interference. Shutting off
power to the dishwasher (at the fuse or circuit breaker) could correct
the problem. Restore power after 15 seconds and try the cycle again.
Check the guide for things you can do to correct the problem.
See the
14
What It Means
Not enough water is
entering the dishwasher.
OR
The drain pump could be Unlatch the door. If there is standing
temporarily blocked
(usually caused by food
particles such as cereal).
The water temperature
in the dishwasher did not
reach the proper wash
temperature. This is
usually caused by lack of
hot water coming from the water heater thermostat to 120°F.
household water heater
The temperature sensor
in the dishwasher is not
functioning properly.
Dishwasher may continue
to be used, but it will not
heat water automatically.
Troubleshooting Tips at the back of this manual.
What To Do
Unlatch the door. If there is no water in
the bottom of the dishwasher, check the
water supply to the dishwasher.
¥ Is the dishwasher water supply turned on?
¥
Is the household water supply turned on?
¥ If you use well or cistern water, is the
supply adequate?
If the water supply is adequate, try the
cycle again. If
water in the bottom of the dishwasher,
relatch the door, touch START, then
immediately touch RESET to start the
pump. If continues to appear, you
may need to do this several times to
break up the blockage.
Avoid showers or laundry just prior to
running the dishwasher. (Use the
DELAY START feature to start dishwasher
when the water heater is up to normal
temperature.) Adjust household
.
minimum.
If appears with every cycle and you
know the water from the water heater is
hot (120°F. or more), call for service.
The temperature sensor needs to be
replaced. Call for service.
NOTE: You may continue to use your
dishwasher. For best results adjust your
household water heater thermostat
to 140°F.
repeats, call for service.