GE GSD4410 Owner's Manual page 9

Hide thumbs Also See for GSD4410:
Table of Contents

Advertisement

Load Selection
2
NORMAL For loads of everyday dishes, glasses and cookware with
POTS PANS For heavily soiled dishes or cookware with dried-on or
CHINA CRYSTAL For lightly soiled china and crystal. Water is aerated for a
RINSE HOLD For rinsing partial loads that will be washed later. Make
Options
3
ENERGY SAVER Shuts off the drying heat options. Dishes air dry naturally
DRY ON and energy is saved. You can prop the door open after the
ENERGY SAVER Turns the drying heater on for fast drying. This cycle will
DRY OFF extend the time to your wash cycle.
DELAY START You can delay the start of a wash cycle for up to 14 hours.
RESET To change a cycle after washing starts, touch the RESET
LOCK When the LOCK pad is touched twice within 3 seconds, all
Start
4
Latch the door and touch the START pad to begin the cycle.
There is a time delay between start-up and water fill so you
will not hear any wash action right away.
medium soils. NOTE: Many dishes have lighter soil than
normal. Choosing a cycle other than NORMAL will save
energy and water.
baked-on soils. Everyday dishes may be included. This
cycle will not remove burned-on foods.
gentle wash.
sure ENERGY SAVER DRY is selected. Do not use
detergent or DELAY START with this cycle.
word CLEAN appears in the display.
Tap or press and hold the DELAY START pad to choose
the number of hours you want to delay the start of the
cycle. The machine will count down and start
automatically at the correct time. NOTE: If you forget to
latch the door a reminder signal will beep until you do so.
pad to cancel cycle. After water is pumped out and motor
stops, you can reprogram and restart the dishwasher.
pads become inoperative. You can lock the controls to
prevent any selections from being made. Or you can lock
the controls after you have started a cycle or selected
DELAY START so the cycle or DELAY START is not
interrupted. The word LOCKED appears in the display.
Children cannot accidentally start dishwasher
by touching pads.
To unlock the dishwasher after it has been locked, touch the
LOCK pad twice within 3 seconds. The word LOCKED will
disappear from the display.
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents