GE GSD4410 Owner's Manual page 13

Display What It Means
Drain is blocked. This
indicates that the drain
is so clogged that the
RESET
dishwasher cannot
continue to operate in
a satisfactory manner.
Dishwasher will stop.
Drain sensor is not
functioning.
Dishwasher will
continue cycle along
with a fixed drain period.
There is too much water
in the dishwasher.
RESET
What To Do
Press the RESET pad to stop the beep.
Locate and remove the blockage in the
drain system. To pump any remaining
water out of the machine:
1 Latch the door.
2 Select any cycle.
3 Touch START and then immediately
touch RESET.
NOTE: Warranty service does not
cover household drain problems.
If repeats for the next cycle, call
for service.
Press the RESET pad to stop the beep.
The dishwasher is designed to
automatically pump out extra water as
long as the door is latched. When you
hear the motor stop running:
1 Unlatch the door and see if all the
water is gone.
2 If you see water entering the
dishwasher, close and latch the door.
Shut off the water supply to the
dishwasher.
3 If water is gone and no water is
entering the dishwasher, restart cycle.
4 If repeats, shut off the water
supply to the dishwasher. Call for
service.
13