D-Link NetDefend DFL-210 User Manual page 90

3.3.2. Ethernet Interfaces
Web Interface
1. Go to Interfaces > Ethernet
2. Select the Ethernet interface of interest
3. Enable the Enable DHCP client option
4. Click OK
3.3.2.1. Useful CLI Commands for Ethernet Interfaces
This section summarizes the CLI commands most commonly used for examining and manipulating
NetDefendOS Ethernet interfaces.
Ethernet interfaces can also be examined through the Web Interface but for some operations the CLI
must be used.
To show the current interface assigned to the IP address wan_ip:
gw-world:/> show Address IP4Address InterfaceAddresses/wan_ip
---------------------
UserAuthGroups:
NoDefinedCredentials:
To show the current interface assigned to the network wan_net:
gw-world:/> show Address IP4Address InterfaceAddresses/wan_net
---------------------
UserAuthGroups:
NoDefinedCredentials:
To show the current interface assigned to the gateway wan_gw:
gw-world:/> show Address IP4Address InterfaceAddresses/wan_gw
---------------------
UserAuthGroups:
NoDefinedCredentials:
By using the tab key at the end of a line, tab completion can be used to complete the command:
gw-world:/> show Address IP4Address InterfaceAddresses/wan_<tab>
[<Category>] [<Type> [<Identifier>]]:
InterfaceAddresses/wan_br
InterfaceAddresses/wan_dns1
InterfaceAddresses/wan_dns2
Property Value
---------------------------
Name: wan_ip
Address: 0.0.0.0
<empty>
No
Comments: IP address of interface wan
Property Value
------------------------
Name: wan_net
Address: 0.0.0.0/0
<empty>
No
Comments: Network on interface wan
Property Value
---------------------------------
Name: wan_gw
Address: 0.0.0.0
<empty>
No
Comments: Default gateway for interface wan
InterfaceAddresses/wan_gw
InterfaceAddresses/wan_ip
InterfaceAddresses/wan_net
90
Chapter 3. Fundamentals