Table of Contents
Advertisement
Quick Start
DFL-900 is an integrated all-in-one solution that can facilitate the maximum security and the best resource utilization for
the enterprises. It contains a high-performance stateful packet inspection (SPI) Firewall (400Mbps at 3000 rules),
policy-based NAT, wire-speed VPN (simultaneous 2000 tunnels), upgradeable Intrusion Detection System, Dynamic
Routing, Content Filtering, Bandwidth Management, WAN Load Balancer, and other solutions in a single box. It is
one of the most cost-effective all-in-one solutions for enterprises.
1.1
Before You Begin
Prepare a computer with an Ethernet adapter for configuring the DFL-900. The default IP address for the DFL-900 is
192.168.1.254 (LAN1, Port 2) with a Subnet Mask of 255.255.255.0. You will need to assign your computer a Static IP
address within the same range as the DFL-900's IP address, say 192.168.1.2, to configure the DFL-900.
1.2
Check Your Package Contents
These are the items included with your DFL-900 purchase as Figure 1-1. They are the following items
1. DFL-900 Device * 1
2. Ethernet cable (RJ-45) * 1
3. RS-232 console * 1
4. CD (include User's manual and Quick Guide) * 1
5. Power code * 1
Figure 1-1 All items in the DFL-900 package
1.3
Device default value
You should have an Internet account already set up and have been given most of the following information as Table 1-1.
Fill out this table when you edit the web configuration of DFL-900.
This chapter introduces how to quick setup the DFL-900.
If any of the items are
missing, please contact your
reseller.
3
DFL-900 User Manual
Chapter 1
Quick Start
Advertisement
Table of Contents
