Table of Contents
Advertisement
D-Link
Step 4.c ¡ X
PPPoE client
If PPP over Ethernet is selected, enter the
ISP-given User Name, Password and the optional
Service Name. Click Next to proceed.
Step 5 ¡ Ð
System Status
Here we select PPPoE method in WAN1 port. Then
the DFL-900 provides a short summary of the
system. Please check if anything mentioned above
is properly set into the system. Click Finish to
close the wizard.
1.7
Internet Connectivity
After setting up DFL-900 with the wizard, DFL-900 can connect to the ISP. In this chapter, we introduce LAN1-to-WAN1
Connectivity to explain how the computers under LAN1 can access the Internet through DFL-900. Subsequently, we introduce
WAN1-to-DMZ1 Connectivity to explain how the servers under DMZ1 can be accessed by the LAN1 users and other Internet users
on the WAN1 side.
You MUST press Apply to proceed to the next page. Once applying any changes, the settings are immediately
1.7.1 LAN1-to-WAN1 Connectivity
The LAN Settings page allows you to modify the IP address and Subnet Mask that will identify the DFL-900 on your LAN. This is
the IP address you will enter in the URL field of your web browser to connect to the DFL-900. It is also the IP address that all of the
computers and devices on your LAN will use as their Default Gateway.
BASIC SETUP > Wizard > Next > PPPoE
BASIC SETUP > Wizard > Next > Next
updated into the flash memory.
8
Part I
Advertisement
Table of Contents
