From Dmz1 To Configure Dfl-900 Lan1 Network Settings; From Cli (Command Line Interface) To Configure Dfl-900 Lan1 Network Settings - D-Link DFL-900 User Manual

Firewall/vpn router
Hide thumbs Also See for DFL-900:
Table of Contents

Advertisement

D-Link
and then logout the system. That will clean up the zombie left in the system so you will be able to login to the DFL-900 from the
LAN1 side after your computer's IP is changed into the new subnet.
We provide two normal ways to configure the LAN1 IP address. One is to configure the LAN1 IP from another port such as DMZ1.
The other is to configure the LAN1 IP through console. Note that when setting the IP address from console, the settings are updated
into run-time system but not stored into the flash. Namely, the settings will be lost after you reboot the system. So, it is best to use
the first method for setting the LAN1 IP address.

2.2.1 From DMZ1 to configure DFL-900 LAN1 network settings

Step 1 ¡ Ð
Check NAT Status
In the DMZ_1 region, use a PC located 10.1.1.X
to connect DFL-900 DMZ1 port (10.1.1.254).
Type https://10.1.1.254 to configure the DFL-900
in the web browser.
Step 2 ¡ Ð
Setup LAN1 IP information
Enter the IP Address and IP Subnet Mask with
192.168.40.254 / 255.255.255.0 and click
Apply.

2.2.2 From CLI (command line interface) to configure DFL-900 LAN1 network settings

Step 1 ¡ Ð
Use Console port to configure
DFL-900
Use the supplied console line to connect the PC
to the Diagnostic RS-232 socket of the DFL-900.
Start a new connection using the HyperTerminal
with parameters: No Parity, 8 Data bits, 1
stop bit, and baud rate 9600. Enter admin
for user name and admin for password to login.
After logging into DFL-900, enter the commands
"en" to enter the privileged mode. Enter the
command
"IP
ifconfig
192.168.40.254" to change the IP of the LAN1
interface.
Use an IE 6.0 at 10.1.1.1 to connect to https://10.1.1.254
BASIC SETUP > LAN Settings > LAN1 Status
DFL-900> en
DFL-900# IP ifconfig INTF1 192.168.40.254 255.255.255.0
DFL-900# IP ifconfig INTF1
LAN1: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
address: 00:50:fc:ba:db:fe
media: Ethernet autoselect (100baseTX full-duplex)
status: active
inet 192.168.40.254 Netmask 0xffffff00 broadcast 192.168.40.255
INTF1
14
Part I

Advertisement

Table of Contents
loading

Table of Contents