Bosch Security System User Manual page 46

3. The display shows *System
Command*.
4
4. Press the key, followed by the
4 key.
If you prefer, you may use the Command Menu in
place of steps 2 and 3 to initiate this function.
Press the Menu> key to enter the Command
Menu, then press Next> repeatedly until you
reach the WALK TEST ?> prompt. Press the
WALK TEST ?> soft key.
Bosch Security Systems | 9/04 | 4998122475D
Security System | User's Guide | Part II: System Commands - WALK TEST ? (COMMAND + 4 + 4)
+
5. The burglary bell sounds for two
seconds.
When the display shows ###
points remain to be tested you
can begin. (### is the number
of points)
If you know the point number, you can enter it by
pressing its number key and then the ENTER key
The display will change to show the point that
was entered. If the point is invalid the message
Invalid Point or This is not a valid walk point
appears.
46