Diagnostics - D-Link DSL-2544N User Manual

Section 3 – Web Configuration
IP Address
Choose MAINTENANCE > Access Controls > Remote Access Control. The
page shown as the figure appears on the right.
In this page, you can configure the IP address for access control list (ACL). If ACL
is enabled, only devices with the specified IP addresses can access the device.
Note:
If you enable the ACL, ensure that IP address of the host is in the ACL list.
To add an IP address to the IP list, click Add. The page shown in the figure
appears on the right.
Click Apply to save the settings, and then choose Enable Access Control Mode
to enable ACL.

Diagnostics

DSL Test
Choose MAINTENANCE > Diagnostic > DSL Test, the page shown as the figure
appears on the right. In this page, you can test your DSL connection.
This page is used to test the connection to your local network, the connection to
your DSL service provider, and the connection to your Internet service provider.
Click Rerun Diagnostics Test to run diagnostics.
D-Link DSL-2544N User Manual 58