Local Ipv6 Network - D-Link DSL-2544N User Manual

Section 3 – Web Configuration

Local IPv6 Network

Choose SETUP > Local IPv6 Network. The IPv6 Local Network page is shown as
the figure appears on the right. In this page, you can set an IP address for the DSL
IPv6 router, enable the DHCPv6 server, enable RADVD and enable the MLD
snooping function.
Enable RADVD: The router advertisement daemon (RADVD) is run by Linux

or BSD systems acting as IPv6 routers. It sends router advertisement
messages, specified by RFC2461, to a local Ethernet LAN periodically and
when requested by a node sending a router solicitation message. These
messages are required for IPv6 stateless auto-configuration.
Enable DHCPv6 Server: WIDE-DHCPv6 is an open-source implementation of

dynamic host configuration protocol for IPv6 (DHCPv6) originally developed by
the KAME project. The implementation mainly complies with the following
standards: RFC3315, RFC3319, RFC3633, RFC3646, RFC4075, RFC 4272
etc.
LAN Address Config Mode: Set the mode address obtaining mode of LAN

PCs. You may choose Stateless or Stateful.
Start/End Interface ID: The address pool using DHCPv6 for address

assignment under stateful mode.
DHCPv6 Lease Time: The address lease time using DHCPv6 for address

assignment under stateful mode.
IPv6 DNS Mode

From WAN: DNS is assigned from WAN interface.
-
- Manual: Manually enter the DNS.
Get Prefix Mode

- From WAN: Use the site prefix obtained at the WAN side as the prefix to issue.
- Manual: Manually add a site prefix.
After setting, click the Apply button to save the settings.
D-Link DSL-2544N User Manual 27